Action Hardware

P Style Plug End Extension Springs for One Piece Garage Doors

SKU:
PLUG-END-SPRING
Write a Review
  • Usually Ships Following Business Day
  • Shipping Cost? For the cost of shipping your item please add the item into the shopping cart. Once the part is in the cart fill out address information in the cart under the Shipping area in the Summary section. Our system will then calculate the shipping fee based on your location and the weight of the product. This is all done before you are asked to provide payment information.

Plug-End - P-Style Extension Spring For One-Piece Garage Doors are metal coils for lifting and tensioning assemblies for opening and closing garage doors. Its primary application is for the E900-R Tension-Spring Assembly. This family of springs provides the key mechanical tension required to lift single-panel, tilt-up garage doors. Crafted with tolerances of 1/100ths of an inch, these are designed to safely and reliably provide long-term, smooth open and close.

These 28 to 32 inch (uncoiled length) springs have an attached closed-end loop, greatly enhancing the security of the hooks used in the tensioning mechanism to anchor the spring. Large, worn-out extension springs will affect every part of a garage doors operation and can be dangerous. Replacing all springs at the same time is highly recommended to ensure smooth lift and operation of the door.

PRODUCT HIGHLIGHTS | SPECS | TECHS

  • Safety-minded replacement or upgrade tension spring for one-piece garage doors

  • Rated for 9000 cycles of operation

  • Change-out of C or W-Hooks used for joining springs to larger mechanism is recommended

  • 97509800 C-Hook for single spring setups

  • CW15 W-Hook for double spring setups

  • Variety of sizes and compatibilities

HOW TO DETERMINE YOUR WIRE SIZE:

  • 1st Letter: style of spring closure/hook (P means plug-end)

  • 1st Number: gauge or size of wire

  • Final 2 Numbers: these tell the length of the spring

  • If the label on your spring is missing: Use calipers or a tape measure 10 rows of coils and divide total by 10; this will be measurement to select in the drop-down menu in cart

Available sizes (see drop down)

  • P728 - 28 in. Plug-End Spring (.177 in. #7 Wire)

  • P728L - 28 in. Low Tension Plug-End Spring (.177 in. #7 Wire)

  • P730 - 30 in. Plug-End Spring (.177 in. #7 Wire)

  • P528 - 28 in. Plug-End Spring (.207 in. #5 Wire)

  • P928 - 28 in. Plug-End Spring (.148 in. 9-Gauge Wire)

  • P732 - 32 in. Plug-End Spring (.177 in. #7 Wire)

  • P328 - 28 in. Plug-End Spring (.244 in. #3 Wire)