Clopay EZ-Set Torsion Tube Coupler

SKU:: 0122530

Write a Review

Usually Ships Following Business Day

UPC:

Shipping Cost? For the cost of shipping your item please add the item into the shopping cart. Once the part is in the cart fill out address information in the cart under the Shipping area in the Summary section. Our system will then calculate the shipping fee based on your location and the weight of the product. This is all done before you are asked to provide payment information.

Product Description
Related Products

Product Description

Clopay’s 0122530 Torsion Tube Coupler for residential garage doors using the EZ-Set torsion spring system. The tube coupler connects two hollow shafts firmly together to act as one torsion shaft with two #14 x 5/8“ sheet metal screws. Once coupled the two shafts hold the torsion springs in place and allow the cable drums to rotate together and raise/lower the door. This garage door torsion shaft coupler comes equipped with two holes where the hollow tube slides in. When it is attached to each shaft the holes are used as a guide to drill two pilot holes into the shafts for sheet metal screws. One 0122530 coupler is included in every EZ-Set Torsion Kit from Action Industries.

Features:

Connects two hollow torsion shafts to act as one
Designed for a DIY installation with the EZ-Set 0122450 garage door center bracket
Compatible with EZ-Set Torsion Systems
One coupler is included in every EZ-Set Torsion Kit from Action Industries
Opposing holes at each end for drilling pilot holes into torsion tubes
Mounts to shafts with #15 x 5/8“ sheet metal screws